How to change wheels
The wheels are the part of the rollerblades that are worn out most quickly. Changing the wheels will in most cases give your skates the feeling of being brand new. Luckily you can easily change the wheels yourself - Just follow this guide and you will be out rolling in no time.
Necessary tool: An Allen key or a skate-tool (For some skates you might need 2 tools, one for each side of the wheel).
Use the tool on the bolt that holds the axle. In some cases, you will need two tools or Allen keys as shown in the picture above.
When the bolt is loose, the axle and screw can be removed. Also, remove the old wheel from the frame.
At this point is a good idea to clean the frame and the bearings. Therefore we recommend, that you wipe off dirt with a dry cloth from where the wheel was positioned.
Use a skate-tool or an Allen key to remove the bearings from the old wheel. If you want to reuse the bearings in the new wheel, then wipe off all dirt from the bearings with a dry cloth. You might also want to clean your bearings. Read more about how to clean your bearings in this guide.
Beside the bearings, a spacer is also located in the wheel. This spacer should also be used in the new wheel (Please note, that some skates have 2- or 3-divided spacers).
Place the bearings and spacer in the new wheel. The bearings should fit tightly. (if the bearings do not fit tightly, play in the wheel occurs, which should be avoided. Find better wheels with a tighter hub)
The new wheel is ready for refitting. Place the new wheel at the empty spot in the frame.
Put an axle through the wheel and place the screw. Tighten the screw with the skate-tool. The screw should be tightened pretty hard, but not so hard that the wheel is not able to rotate freely.
Repeat the same procedure for all wheels. New wheels usually have a larger diameter than the worn wheels. Therefore you will be able to skate faster, so take care the first time you use your skates after a wheel change.